#WANSCAM SEARCH TOOL.EXE INSTALL#
#WANSCAM SEARCH TOOL.EXE PASSWORD#

But the most important is, that you check if your email client has SMTPĢ) FTP service is a precondition for the alarm function. If you use Gmail, you mustĬonfigure the port as 465, SSL as TLS.

Note: This function only works if the IP camera is connected to the network. Here the configuration of a Gmail account as example: Precondition for this is theĬorrect setup and test of the service. If the motion detectĪctivates your camera is triggered, you will receive an email containing photos. Alarm Notification Setting & Email, FTPġ) The email configuration screen serves for the preparation of the alarm function. Alarm Settings & Motion Detection Configurationġ) First, you should activate the “Motion detection” and choose the display detail that should be monitoredĢ) You may choose the “Alarm trigger ringtone” and time schedule, then click on ”Apply”, If the motionĭetect detects a motion in the configured display detail the alarm bell will ring (The model without audioįunction is not provided with this alarm ring tone notification)Ĩ. Icon to access the “ Device information” settingsĢ) You will see all information for the IP cameraĢ) You may choose any NTP server, then click on “Apply”ģ) Choose the desired time and click on “Apply” to activate itģ) Choose between ”First stream” or ”Second stream”Ĥ) Choose the time schedule for recordingħ. Note: If the camera IP Address can not be found by the search tool, please connect the internet cableĬhecking the WIFI signal connection status If correct, just go back to select “Apply”, then disconnect the network cable. Make sure that all parameters are the same like in your router, enter the WIFI network key.Ĭlick on “Check”, after 30 seconds, the notification will show you if the WIFI settings are successful. Search for the WIFI signals and choose the desired SSID. Refresh the webpage and login again, the camera video will be displayed as belowīutton to access the “Wireless settings”. Note: If the OCX already has been installed you may login directly. (It supports 6 visitors watching online at the same time)

#WANSCAM SEARCH TOOL.EXE PASSWORD#

(Please change the account user name and password for safety later)Īfter entering the correct user name and password, the Login screen will be displayed. Note: Both the username and password are “admin” In your default browser a login screen like shown below will be displayed: Note: If the Search Tool issues the message 'Subnet mask does not match, please clickĭouble click the camera IP address in the search tool. Open the File “Search Tool”, Copy the “Search Tool” to the desktop and launch it.Īfter the hardware is connected properly, launch the search tool, and the IP address of the camera will be Open the File 'Browser view' Open 'HW”, click on “OCX setup” - “Next” - “Install” - “Finish”Ģ.

#WANSCAM SEARCH TOOL.EXE INSTALL#

Insert the CD and install the following software:ġ. Note: For the first time use of IP Camera, please refer to the procedures above.Ĭonnect the camera with Internet cable to the router, and with the power cord to the mains, like shown Note: Some models don’t have a separate antenna.

Wanscam search tool.exe